Cisco Unified Communications Manager Express Lab Sim

(Notice: This labsim is only used for CCNA Voice 640-460)

Question

To configure the Cisco Unified Communications Manager Express click on the console host icon that is connected to a Cisco Unified Communications Manager Express by a serial console cable (shown in the diagram as a dashed black line). You can click on the buttons below to view the different windows. Each of the windows can be minimized by clicking on the [-]. You can also reposition a window by dragging it by the title bar.
The “Tab” key and most commands that use the “Control” or “Escape” keys are not supported and not necessary to complete this simulation. The help command does not display all commands of the help system.
Scenario:
You are required to manually configure a Cisco Unified Unified Communications Manager Express to support two IP phones with directory numbers starting with 5001.
The phones need to be configured as dual-line phones as per the following table:

Phone	MAC Address	Primary Directory Number (dual-line) Button 1	Shared Directory Number (dual-line) Button 2
IP Phone 1	0014.1CBC.E179	5001	5010
IP Phone 2	0003.E3C4.463C	5002	5010

The Cisco Unified Communications Manager Express should be configured as a DHCP and TFTP server.
The IP phones should obtain their IP addresses via DHCP in the range 10.3.130.10 – 10.3.130.254. IP addresses in the range 10.3.130.1 to 10.3.130.9 should be excluded.
The IP phones are connected to an EtherSwitch module, interface GigabitEthernet1/0 on a Cisco 2811 router as per the topology diagram. The voice VLAN ID is 130 and default router for the IP phones is 10.3.130.1.
The EtherSwitch module has been preconfigured and is not configurable.
You are also required to configure a second directory number 5010 as a shared directory number on line 2 of each IP phone.
Topology: